- Full moldboard trip with four (4) extension type springs
- 11′ plow length / 33″ inlet, 58″ outlet plow heights (measured w/6″ cutting blade)
- 12′ plow length / 33″ inlet, 60″ outlet plow heights (measured w/6″ cutting blade)
- 3/16″ moldboard
- Eight (8)″ ribs, fully welded (8 3/8″ counting endplate)
- Two (2) heavy duty 4″x 19″ reversing cylinders with 2″ nitrated rods
- Cylinders are mounted above the push frame
- Push frame is 102″ wide with six (6) main hinge points
- Push frame constructed with 3/8″x 4″x 4″ square tubing
- 3/4″x 4″x 4″ lower angle
- Adjustable attack angles – 10 & 20 degrees
- 5/8″x 8″ cutting edge with standard AASHO punch
- Various hitches available, plow & truck portions
- 10ga. 201 or 304 stainless steel moldboard in lieu of standard
- DXV Cushion valve to protect reversing cylinders (shipped loose)
- Rubber snow flap, 3-ply, 1/2″ thick x 12″ wide (installed with carbon steel retainer bar)
- Rubber snow flap, 3-ply, 1/2″ thick x 18″ wide (installed with carbon steel retainer bar)
- Stainless Steel retainer bar, bolts, and nuts for rubber flap in lieu of carbon steel
- Plow end markers, 27″ red cable type (installed)
- Plow end markers, 36″ orange cable type (installed)
- Plow end markers, 28″ orange plastic type (installed)
- Plow end markers, 36″ orange plastic type (installed)
- Plow end markers, 48″ orange plastic type (installed)
- Crank adjustable parking stand, (installed)
- Heavy Duty push frame
- Shoe brackets only, installed (no shoe assembly included) (need to order shoe assembly separate)
- Adjustable mushroom shoes with standard pads (installed)
- Adjustable mushroom shoes with Ni-Hard pads (installed)
- Adjustable shoes with Flat shoe pad style (installed)
- Snow Wheel Shoe brackets & Snow Wheel Assembly
- One Piece Trip Cutting Edge in lieu of moldboard trip (10′ & 11′ plow)
- One Piece Trip Cutting Edge in lieu of moldboard trip (12′ plow)
- Three piece trip cutting edge in lieu of moldboard trip (11′ & 12′ plows only)
- Moldboard Trip/Trip cutting edge combination
- Individually replaceable trip springs in lieu of standard trip springs (all trip edge plows)
- 3/4″ x 4″ x 4″ lower trip edge angle ILO std. 1/2″ x 3″ x 4″ (all trip edge plows)
- Curb shoe (installed)
- Cutting edge shoe (installed)
- Carbide cutting blades 3/4″ x 6″
- 3/4” re-rod welded to each end of the plow
- Guard rail corner cut
- Mailbox cut
- Weld on Customer ID Numbers on the Plow Moldboard (location details are required)
- 3/16″ moldboard in lieu of standard
- 10ga. 201 or 304 stainless steel moldboard in lieu of standard
- 7ga. 201 or 304 stainless steel moldboard in lieu of standard
Social