Standard Features:
- Full moldboard trip with four (4) extension type springs
- Two (2) extension type springs on a 38" high plow
- 10'/11'/12' standard plow lengths
- 38"/43"/46"/48" plow heights (measured with 6" cutting blade)
- 10 ga. moldboard
- Six (6) 1/2" ribs, fully welded
- One (1) heavy duty 4"x 13" reversing cylinder with 2" nitrated rod
- Cylinder is mounted above the push frame
- Push frame is 65" wide with four (4) main hinge points (see options)
- Push frame is constructed with 1/2"x 4"x 8" angle iron
- 3/4"x 4"x 4" lower angle
- 5/8"x 8" cutting edge with standard A.A.S.H.O. punch
- Plow lifts level and reverses level
- Various hitches available, plow and truck portions
Options:
- Also available with trip cutting edge & combination trip cutting edge/moldboard trip
- Longer plow lengths available upon request
- Heavy Duty Push frame (HDP) is 112" wide and constructed with 1/2"x 4"x 8" angle iron, Eight (8) 1/2" ribs (in lieu of six), fully welded, Six (6) main hinge points (in lieu of four), with the furthest hinge point extending about 18" from the end of the plow
- Adjustable mushroom shoe pads, standard or Ni-hard or flat shoe pads
- Plow markers – plastic or cable
- Rubber snow deflector
- Carbide blades
- DXV Cushion Valve to protect reversing cylinder
- Available in BHW Model (Warped Board) Height is 46". Moldboard has larger curl/belly and a more relaxed cutting edge (approx. 26 degrees). This design will throw snow better and is more suitable for gravel and seal coated roads.
Literature:
